Comments

Plug a hole in a wall

Plug a hole in a wall



We are searching data for your request:

Forums and discussions:
Manuals and reference books:
Data from registers:
Wait the end of the search in all databases.
Upon completion, a link will appear to access the found materials.

Plug an ankle hole

It is important to clean the surface on which you are going to work. With emery paper, sand the hole and its surroundings to remove any roughness that might have appeared by removing the offending nail or dowel. Then, just fill the hollow with plaster, being careful not to make too thick layers. Better to favor several passages over the hole. After allowing to dry, smooth the plaster and remove the excess material.

Repairing an unfortunate grip

If when you open a door, the handle bangs against the wall, there is a good chance that the plaster on the wall will be pressed in. In this case, it is first important to clean and level the part to be repaired. For this, a brush stroke removes the pieces of plaster, plaster or destroyed wallpaper. Then the idea is to apply cement, possibly after delimiting the part to be worked with a grid or fiberglass. Once the hole is filled in and the cement has set, all that remains is to remove the excess.

Some tips for applying plaster or cement

To be sure that the coating applied to the hole to be plugged up, it is advisable to pass several layers in different directions: the first in horizontal, the second in vertical… Then, the fact of coating by showing asperities on the layer also allows better adhesion. You just have to apply your paste by drawing wavelets with the coating knife.